Before you call

Six things worth checking before you call anyone

Before you book a repair, check the drain filter, the tap and inlet hose, the socket, a chimney's oil cup and filters, an AC's filters and mode, and whether a washing machine is level. None of these takes more than ten minutes, and if one of them fixes the problem you owe nothing.

By Kaif Sharieff, Fixit BLR · published · reviewed

New drain pump going into the base of a washing machine, the old pump lying on the mat

What each check rules out

Six free checks, how long each takes, and the fault each one rules out before you pay for a visit
CheckTimeWhat it rules out
Drain filter10 minA drain pump at ₹1,199 to ₹3,199 fitted
Tap and inlet hose3 minAn inlet valve, and many washing machines that will not fill
The socket2 minA dead board, when the real fault is a socket with no power
Chimney oil cup and filters5 minA suction motor at ₹2,099 to ₹6,799 fitted
AC filters and mode5 minA gas charge at ₹2,499 to ₹4,499, on an AC that only needed clean filters
Level and transit bolts5 minA bearing set, and the damage that leads to one

Before you open a filter, a flap or a cover, switch the appliance off at the wall socket. None of these checks needs a screwdriver or a panel opened, and none involves wiring. If you smell burning or see scorch marks, keep the appliance switched off and book a visit.

1. The drain filter, on a washing machine

A coin, a button or months of lint in the drain filter stops the water draining, and the machine shows the same symptom and the same error code as a failed pump.

  1. Wait for the water to cool if the last wash was hot.
  2. Spread a towel in front of the machine and set a shallow tray under the filter flap. About 1 to 2 litres will come out.
  3. Unscrew the filter anticlockwise, clear it, rinse it and screw it back in firmly, or it will leak on the next wash.

2. The tap and the inlet hose

A tap that was turned down and never turned back up, or a hose squashed behind the machine, stops a washing machine filling just as a failed inlet valve would.

  1. Open the tap fully.
  2. Pull the machine forward a little and straighten the hose.
  3. Close the tap, undo the hose where it meets the tap, and rinse the small mesh filter inside it. On water above 400 ppm, as in most of the outer east, that filter can block within 6 to 12 months.

3. The socket

Before you decide the appliance is dead, plug a lamp or a phone charger into the same socket. If that does not work either, look for a tripped MCB in the distribution board, and take any extension board out of the line. This takes 2 minutes.

4. The oil cup and filters, on a chimney

A full oil collector cup is the usual reason oil drips back onto the hob. Empty it and wash it. Then, with the chimney running, hold a sheet of paper against the filters. If the paper does not stay up, the filters are choked and the motor is probably fine. A clean costs far less than a ₹2,099 to ₹6,799 motor.

5. The filters and the mode, on an AC

  1. Switch the AC off. Lift the front panel of the indoor unit and slide out the two mesh filters.
  2. If they are grey with dust, rinse them under a tap and let them dry fully before you put them back.
  3. Set the remote to Cool, the snowflake symbol, at 24 degrees, and make sure it is not on Fan or Dry.
  4. If the indoor unit blows air but the outdoor unit stays silent, check the AC's own MCB and the stabiliser before you book.

6. Level and transit bolts, on a washing machine

A washing machine that walks across the floor is usually not level, or still has four transit bolts in the back panel from the day it was delivered. Both are free to fix with a spanner in under 5 minutes. Left for a year, both can damage the drum bearings.

If none of that works

Then it needs a technician. When you book, tell us which of the six checks you tried, along with the brand and any error code. We note it on the job, so the technician knows what has been ruled out and can bring the likely part.

Questions

If one of these fixes it, what do I owe you?

Nothing. There is no charge for advice, and no charge for a booking you cancel before the technician arrives. The visit fee, from ₹299, applies only once someone has come to your door, so emptying an oil cup yourself costs you nothing.

Is it safe to open the drain filter myself?

Yes, with the machine switched off at the socket, the cycle finished and the water cool. Tilt the machine back slightly, keep a towel and a shallow tray under the flap, and expect 1 to 2 litres of water. Turn the filter anticlockwise, rinse it, check the housing for a coin, and screw it back in firmly or it will leak on the next wash.

How long do all six checks take?

About half an hour in total, and you need nothing more than a torch and a spanner for the transit bolts. The socket test takes 2 minutes and the tap and hose check 3 minutes. Nothing on the list needs a panel opened or wiring touched.

What should I tell you when I book?

Tell us the appliance, the brand, the model number if you can photograph the rating plate, any error code on the display, and which of the six checks you already tried. That saves time at the visit and helps the technician bring the right spare.

Pages that go with this

We repair all major appliance brands

We repair every make out of warranty, across Bengaluru. Tap yours to book.

Still not working? Book now, pay after the job.

Tell us what it is doing and we will tell you what it usually is, and what it usually costs, before anyone comes out.

Book a repair

A person calls you back within 10 minutes.

1Which appliance? Tap one
2What is wrong? Tap one
3Where do we call you?
  • Visit from ₹299, taken off your repair bill if you go ahead
  • Pay after the repair
  • No advance, no OTP

Your details are used to arrange your repair. Privacy

Not sure what it is? Send a photo on WhatsApp